The DMX512.com Forum

General Category => DMX512 Discussions => Topic started by: Mr Ray on September 25, 2011, 08:13:24 AM

Title: Is there a standard procedure for adressing without dipswitches?
Post by: Mr Ray on September 25, 2011, 08:13:24 AM

Bought some used rgb-led "fixtures" produced by XAL (Squadroled 400 050-26767). Now having problem to put in their start-adress. There is a connection marked ADR-IN and one ADR-OUT, a fourth connection beside the bus three. Is there a standard for this connection, and what signal do I send to this connection?